Anybody put their Sti7 on a dyno yet?
#1
Just curious to compare the manufacturers specs as compared to actual figures.
I know that some of the figures coming out of Japan can be considered dodgy at times (EvoVII).
Anybody?
I know that some of the figures coming out of Japan can be considered dodgy at times (EvoVII).
Anybody?
#4
Popped into PE yesterday, and saw some dyno plots of a couple of STI 7's with PE exhaust system. They didnt have the before plots, but with the mods the STI's were putting out 300bhp and 275lbft.
We also overlayed my old STI 5 with same mods except for no cat (PE system still has a cat in the downpipe). My STI 5 came in little earlier, but the STI 7 really hangs onto the power where the old shape took a nose dive. Peak power in the 7 seemed very close to the red line.
Jonathan
We also overlayed my old STI 5 with same mods except for no cat (PE system still has a cat in the downpipe). My STI 5 came in little earlier, but the STI 7 really hangs onto the power where the old shape took a nose dive. Peak power in the 7 seemed very close to the red line.
Jonathan
#5
My STI7 (UK) went on the PE road when it was very young. Had 264 bhp and 248lbft. The interesting thing is the torque. It peaks at about 4000 rpm and then falls right off, which you can tell when you drive it. There was a japanese import the same day and the tester was surprised by the difference when he tested the cars as he thought mine was an import as well (it's debadged) so it's obviously noticeable.
Trending Topics
#11
300bhp & 284 lbft with PE T75 system only mod. (incl. sports cat)
Was dyno'd @ 311bhp & 293-ish lbft prior to restrictor being fitted
Like Chins says, peak power @ 7450rpm.
No major overboost problems like some STI UK owners. Peaking @ 1.3bar, then level at just over 1 bar.
[Edited by Paul N P - 4/18/2002 8:27:05 PM]
Was dyno'd @ 311bhp & 293-ish lbft prior to restrictor being fitted
Like Chins says, peak power @ 7450rpm.
No major overboost problems like some STI UK owners. Peaking @ 1.3bar, then level at just over 1 bar.
[Edited by Paul N P - 4/18/2002 8:27:05 PM]
Thread
Thread Starter
Forum
Replies
Last Post
hedgecutter
General Technical
3
25 September 2015 02:35 PM