Key fob in washing machine?
#2
Scooby Regular
iTrader: (1)
Join Date: Feb 2007
Location: Here
Posts: 1,605
Likes: 0
Received 0 Likes
on
0 Posts
dont press any buttons and remove the battery, leave in a warm place to dry out,
Once dry put battery(may need new one) back in and you should be fine,
If you start pressing the buttons before its dry you may kill it off.
hth
Once dry put battery(may need new one) back in and you should be fine,
If you start pressing the buttons before its dry you may kill it off.
hth
#3
Moderator
iTrader: (1)
As above. Take it apart and leave it apart until its dry.
If you have any electrical contact cleaner, its worth giving the circuit board a good spray to rinse off any remaining suds and prevent it corroding any further, it'll help it dry out quicker too.
I've done the above with a Samsung Tocco Ultra....it still works fine
If you have any electrical contact cleaner, its worth giving the circuit board a good spray to rinse off any remaining suds and prevent it corroding any further, it'll help it dry out quicker too.
I've done the above with a Samsung Tocco Ultra....it still works fine
#4
Scooby Regular
iTrader: (2)
As above. Take it apart and leave it apart until its dry.
If you have any electrical contact cleaner, its worth giving the circuit board a good spray to rinse off any remaining suds and prevent it corroding any further, it'll help it dry out quicker too.
I've done the above with a Samsung Tocco Ultra....it still works fine
If you have any electrical contact cleaner, its worth giving the circuit board a good spray to rinse off any remaining suds and prevent it corroding any further, it'll help it dry out quicker too.
I've done the above with a Samsung Tocco Ultra....it still works fine
My youngest dropped a decent phone into his pint. I dried it out and the only bit that doesn't work is the camera.
#5
Moderator
iTrader: (1)
Camera still works, but the picture taken always have a few water marks
Its not the first time its happened: I managed to save a SE W810 in the same way, but the loud-speaker didn't survive
Last edited by ALi-B; 11 October 2010 at 11:55 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
toyney83
General Technical
10
02 October 2015 08:38 PM