i need to replace the osf inner cv boot i have used the search box and come back with sumthing about a pin where abouts is the pin dose any1 have any pictures of this please would be very greatfull thanks in advance

 

bump

 

its on the cv joint itself, its a roll pin u have to knock out with a drift. iv had both my shafts off, its a piece of cake. u may have to rotate the shaft to locate it but u cant miss it. my cv joints are green and the pin goes through the cv. one end of the roll pin hole is chamfered, thats the end u put it back through. also the shaft has to go back on the same way, if its rotated 180degrees the pin wont go in.

 

wicked it is the pin i saw then thanks very much