Airbag Removal - Resistor
#1
Airbag Removal - Resistor
I am about to change the Classic 99/00 dash on the Scoob. The new dash is fitted with a top cubby box instead of the passenger airbag.
I have tried the Tech in electrics area but had no replies. I'll need a resistor to stop the Airbag light being on all the time.
Where can I get the resistor from and what type etc would I need?
Ta
I have tried the Tech in electrics area but had no replies. I'll need a resistor to stop the Airbag light being on all the time.
Where can I get the resistor from and what type etc would I need?
Ta
#4
Scooby Regular
Join Date: Oct 2003
Location: East Yorkshire
Posts: 1,966
Likes: 0
Received 0 Likes
on
0 Posts
I used 2.2 ohm (0.25W IIRC, small one anyway) resistor from maplin (mail order) with success. Just fold over the end wires once to make a snug fit in connector then tape up.
http://cgi.ebay.co.uk/10-x-2-2-Ohm-0...ts_Supplies_ET
http://cgi.ebay.co.uk/10-x-2-2-Ohm-0...ts_Supplies_ET
Last edited by D1CCY; 01 September 2010 at 10:18 AM. Reason: Maplin don't do anymore, found alternative source.
#5
Many thanks. Off to Maplins. I suppose it cheaper than this
http://www.capitalseating.co.uk/prod...&appid=&rid=61
http://www.capitalseating.co.uk/prod...&appid=&rid=61
Thread
Thread Starter
Forum
Replies
Last Post