Brake disc run out!
#1
Scooby Regular
Thread Starter
iTrader: (6)
Join Date: Jun 2008
Location: ottery st mary,near exeter
Posts: 538
Likes: 0
Received 0 Likes
on
0 Posts
Brake disc run out!
hi what would be the maximum run out on a front disc on a 2000 turbo before you would feel slight pedal/steering wheel vibration?
thanks
thanks
#4
Scooby Regular
Thread Starter
iTrader: (6)
Join Date: Jun 2008
Location: ottery st mary,near exeter
Posts: 538
Likes: 0
Received 0 Likes
on
0 Posts
just under braking,i have jacked it up and brakes are free! you can feel it at 40mph plus! been told to rotate the discs one hole and try that??
the discs and pads are only a couple months old!
the discs and pads are only a couple months old!
Last edited by danny c; 17 February 2010 at 10:19 PM. Reason: forgot something
#5
You could of warped them from hard driving.I cant see moving the disc round 1 hole would do anything.Were the disc mounts to the hub has to be clean when your re fitting discs or them or replacing them or this can warp the discs.
#6
Scooby Regular
Join Date: May 2004
Location: wiltshire
Posts: 657
Likes: 0
Received 0 Likes
on
0 Posts
i got the same problem, shaking steering wheel breaking at 30-40+ mph
only had discs for 3 months, they were a bargain on fleabay but guess you get
what you pay for
only had discs for 3 months, they were a bargain on fleabay but guess you get
what you pay for
Trending Topics
#8
Scooby Regular
Thread Starter
iTrader: (6)
Join Date: Jun 2008
Location: ottery st mary,near exeter
Posts: 538
Likes: 0
Received 0 Likes
on
0 Posts
i jacked the car up and the wheels are free so i dont think the brakes are binding! i read about run out and was mentiond if its out a bit to turn disc one hole?(i didnt really see point either)
thought about fitting old discs and seeing if it made a differance but i threw them out! typical!
thought about fitting old discs and seeing if it made a differance but i threw them out! typical!
#10
THE braking specialist
iTrader: (259)
i jacked the car up and the wheels are free so i dont think the brakes are binding! i read about run out and was mentiond if its out a bit to turn disc one hole?(i didnt really see point either)
thought about fitting old discs and seeing if it made a differance but i threw them out! typical!
thought about fitting old discs and seeing if it made a differance but i threw them out! typical!
We see a lot of calipers every month in need of reconditioning
Cheers Ian
#11
I have seen were 1 pot sizes then stayes in same position and then brakes go free again as it weares pad down.You can get new brake pistons and seal kits from main dealer there not hard to fit if this is your problem.
Thread
Thread Starter
Forum
Replies
Last Post
shorty87
Full Cars Breaking For Spares
19
22 December 2015 11:59 AM
MightyArsenal
Wheels, Tyres & Brakes
6
25 September 2015 08:31 PM