How to decay my 96 version 3 scooby
#1
Scooby Regular
Thread Starter
Join Date: Dec 2009
Location: Inverness Scotland
Posts: 102
Likes: 0
Received 0 Likes
on
0 Posts
How to decat my 96 version 3 scooby
Hi everyone,
can someone advise me on how much it would cost me to decat my version 3 1996 sti??
Also what bits do I need to buy??
Thanks, hopefully I'll get it done after my m.o.t in march
can someone advise me on how much it would cost me to decat my version 3 1996 sti??
Also what bits do I need to buy??
Thanks, hopefully I'll get it done after my m.o.t in march
Last edited by Woody182; 11 January 2010 at 02:28 AM.
#2
AFIK, you just need a catless downpipe as the cat is in the stock downpipe. So all you probably need is the downpipe. So it would be cost of that plus labour. As I don't live in the UK it would be impossible for me to make quotations.
There is also a Resonator that runs on the piping after the downpipe that some mistake for the cat, you may want to get rid of that too or not if you so desire, but clearly it would mean the car getting much louder.
There is also a Resonator that runs on the piping after the downpipe that some mistake for the cat, you may want to get rid of that too or not if you so desire, but clearly it would mean the car getting much louder.
#3
Once you've decatted your P&J you should seriously think about a remap. An ESL daughterboard and remap solution is the way to go.
No point spending all that money on the hardware if you aren't going to update the software to ensure your car makes the best use of your physical mods and more importanly runs properly.
No point spending all that money on the hardware if you aren't going to update the software to ensure your car makes the best use of your physical mods and more importanly runs properly.
#4
Scooby Regular
Thread Starter
Join Date: Dec 2009
Location: Inverness Scotland
Posts: 102
Likes: 0
Received 0 Likes
on
0 Posts
What does P&J mean mate?? Yea I agree mate about the remap! Cause it's had a full hks stainless exhaust system on it , blitz induction, boost gauge, exceddy race clutch ect so most stuff is ready!
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
bluebullet29
General Technical
9
05 October 2015 02:17 PM
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM