Exhaust Wrap
#1
Scooby Regular
Thread Starter
iTrader: (30)
Join Date: Dec 2005
Location: leicester
Posts: 3,508
Likes: 0
Received 0 Likes
on
0 Posts
Exhaust Wrap
going to be wrapping my headers soon
can anyone recormend a source for the heat wrap
have seen it on ebay from like 15 quid upwards but not sure which is best
how much in lengh do people think i might need for standard headers
i know this depends on how wide it is but a rough idea please
also anyone got any do or donts when doing this
or even better a quick guide
cheers phil
can anyone recormend a source for the heat wrap
have seen it on ebay from like 15 quid upwards but not sure which is best
how much in lengh do people think i might need for standard headers
i know this depends on how wide it is but a rough idea please
also anyone got any do or donts when doing this
or even better a quick guide
cheers phil
Last edited by phil739; 24 July 2009 at 07:35 AM.
#2
Dont no about quality but all i can say is rap it out side in the garden because the tiny fibers that fall off every where really ich, as i found out when i raped my in the living room.
the place was covered and every one was ichin lol
the place was covered and every one was ichin lol
#3
Scooby Regular
iTrader: (46)
Join Date: Nov 2005
Location: Probably polishing it.Lol
Posts: 5,381
Likes: 0
Received 0 Likes
on
0 Posts
I wrapped a downpipe and I was amazed at how much it took. I may be wrong but I think it took 10m.
I got mine off ebay although I had info from some of the specialists on hear to buy "theirs" as Ebay stuff is crap. Mine works fine.
Try the tech section.
I got mine off ebay although I had info from some of the specialists on hear to buy "theirs" as Ebay stuff is crap. Mine works fine.
Try the tech section.
#4
Scooby Regular
iTrader: (42)
Another tip is to paint it with high temp paint afterwards, it helps hold it together and helps with it absorbing water when it rains. If it absorbs water it stinks, rots & steams Both times I did mine I used BBQ paint
#5
Scooby Regular
iTrader: (1)
Join Date: Jun 2008
Location: Reigate Surrey
Posts: 2,656
Likes: 0
Received 0 Likes
on
0 Posts
Have you tried PM Harvey on here he does the ported headers and stuff, I got mine from him he is very helpful and will tell you everything you need to know. Word of warning tho its not cheap and you do get through a lot of material, but hay if your going through the trouble to wrap headers then you really only want to do it once with the best possible results, so make sure you buy the good stuff
But buy cheap buy twice
But buy cheap buy twice
Thread
Thread Starter
Forum
Replies
Last Post
fatboy_coach
General Technical
15
18 June 2016 03:48 PM