Std. Header Porting & ECUTEK Mapping
20 April 2009, 03:06 PM
#1
Scooby Regular
Thread Starter
Join Date: Sep 2006
Location: Hertfordshire
Posts: 419
Likes: 0
Received 0 Likes
on
0 Posts
Std. Header Porting & ECUTEK Mapping
Where is the closest place to get my std. headers ported, I'm in Herts?
Also I need an ECUTEK remp, was thinking Jolly Green Monster, has anyone used the before and would recommend, where else is loscal to Herts?
Chris
Also I need an ECUTEK remp, was thinking Jolly Green Monster, has anyone used the before and would recommend, where else is loscal to Herts?
Chris
20 April 2009, 05:31 PM
#2
Scooby Regular
iTrader: (7)
Join Date: May 2006
Location: Milton Keynes or Canterbury
Posts: 422
Likes: 0
Received 0 Likes
on
0 Posts
Ported headers - Harvey from on here seems to be the best bet by general consensus of opinion. Send him a pm and he will get back to you
Jolly Green Monster is a good guy who also happens to be very good at his job. I have not seen a bad word uttered about his work. He has mapped my previous car and is going to map the new one once i have all the bits for it. Again, send him a pm and he will sort you out
Jolly Green Monster is a good guy who also happens to be very good at his job. I have not seen a bad word uttered about his work. He has mapped my previous car and is going to map the new one once i have all the bits for it. Again, send him a pm and he will sort you out
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
