psi3 alarm settings
27 March 2008, 08:59 PM
#1
Scooby Regular
Thread Starter
iTrader: (12)
Join Date: Jun 2007
Location: Moved to the Darkside
Posts: 5,034
Likes: 0
Received 0 Likes
on
0 Posts
psi3 alarm settings
does anyone know where i can find out or can recommend what my alarm settings should be for coolant temp, high volts, low volts etc. Its 05sti ppp by the way
27 March 2008, 11:33 PM
#2
I set the coolant to 100c, high volts to 15, low volts to 10. Boost pressure depends on what your present target is. For PPP I recall a figure of 1.3bar? If so, set the alarm for just above this.
I occasionally see the low volts warning after a cold start!
JohnD
I occasionally see the low volts warning after a cold start!
JohnD
28 March 2008, 12:42 AM
#3
Scooby Regular
iTrader: (1)
Join Date: Dec 2001
Location: You only live ONCE But if you do it right >>>>> ONCE is enough
Posts: 7,327
Likes: 0
Received 0 Likes
on
0 Posts
Mine are similar to John.
My car is mapped @ 1.25 - 1.3 bar so the alarm warns of spikes.
The radiator fans should cut in @ 96C - 97C so if it goes much higher (100C) then it could mean a problem.
When "playing" my oil temp hovers around 100C - 105C so I set the top end alarm figure to remind me to ease up & let things settle down for a bit.
Mark
- Battery voltage low 9.5 volts
- Battery voltage high 15 volts
- Boost pressure 1.35 bar
- Coolant temperature 100C
- Oil temperature 105C
My car is mapped @ 1.25 - 1.3 bar so the alarm warns of spikes.
The radiator fans should cut in @ 96C - 97C so if it goes much higher (100C) then it could mean a problem.
When "playing" my oil temp hovers around 100C - 105C so I set the top end alarm figure to remind me to ease up & let things settle down for a bit.
Mark
my peak boost hit 1.41 bar does this sound ok
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM