i saw a few pics of the front grill where its like a silver mesh most recent on rb320 black one, is this avalble to buy as a aftermarket replacment any help on this would be great it looks a lot like the ones from grillcraft thanks in advance

 

You`ll get them from your local Subaru dealer as a Prodrive accessory. Also do them for the Blobeye.

 

The one from subaru is part number SACC2616 and retails for 275.00 inc vat you can find a picture on there website under accessories.

 

Or if anyone is looking for one for a blobeye the part number is SACC2567 and they cost 225.00 inc vat.

 

See my scooby M8

<<<<<<<<<<<<<<<<<<<<<<

 

Got my grille kit
<-------------
from Scott Lowe. You get the upper and lower kit for around £150 IIRC.

 

And i've just realised you can't see it from those pics.

 

DOHHHH! Gaz

 

bodski...... thats the one i like but for a newage, is that the prodrive kit....? was it easy to fit?

 

bods is a newage, did you mean classic?

Yeah, they're a doddle to fit. Even for an car-illiterate like me.

Number plate off, put rubber rings on prongs, drill bumper in places given. Pop in and screw on. Number plate back on, or leave off for 2m like i did because the double tape wouldn't hold it.

 

i have a newage but the front grill is different to bodski, i have 3 smaller grills up top?

 

Revolution do one to you know?A lot cheaper and much much betterer I think





..and theirs doesn't have that lashed on chicken wire effect

 

elmer what cost is that bottom grill? i liked the prodrive one as my scoob is black and the silver mesh stands out!!! but your looks nice to thanks mate...

 

Just as Gaz says M8, Piece of P1ss to fit on a Blobeye, but as for a Hawkeye i aint got a clue lol

 

check out my pics.. i have the prodrive mesh grille your talking about but in black..

since those pics were taken i have since installed the upper 3 grille sections..

the bottom grille is easy enough to fit, you have to drill 4 holes in the body work.. but the upper 3 sections are a nightmare!! you have to open the bonnet, remove the middle section completely (which is no easy task) and then remove each of the side grille sections, unscrew them, remove the standard mesh, replace it with the prodrive mesh, screw back together, and pop it back into place.

its available from any subaru dealer, just call them and they will order it for you, hope that helps.

 

drtchock, so the bottom prodrive grill is different to the stock upper front i have have a look at my pic`s thanks for your help mate, p.s want my scoob to look like your some day lol.....thanks again

 

yes its different, just sent you a pm

 

thanks mate!!