When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
push the stickie upie thingie on the strip in the bolt hole in the spoiler base and position the spoiler on the boot lid.
The strip ends will stick out under the spoiler, tape both ends to the boot lid and when you lift the spoiler up you then drill through the hole on the stickie up part as this is where you want the hole as it aligns with the bolt hole on the spoiler
I did mine last week - very nervous about drilling 4 holes but it worked
dont forget to use a touch up on the drilled holes or they'll rust (oh and use a sealand to stop water getting in.
Im sure the Orignal four Studs should be loads, might bond it with Stikaflex as well.
This may sound daft, but don't stick it on too well, when i tried to remove mine, i ended up denting the boot lid all the way over from forcing the spoiler off!!