Bell Euro 550 is it working OK ?????
#1
I just received delivery of my Bell Euro 550, I noticed exactly the same problem with mine, it picks up the 1 on the other side but the one infront that matters it dont seem to go off til Im past it, I spoke to networx auto and they said that some of the cameras are not fully functional that is why they dont go off earlier, he said they dont send out a full signal if there not fully functional.
Is this the case perhaps one of u can tell me
Thanks very much
Is this the case perhaps one of u can tell me
Thanks very much
#2
Scooby Regular
iTrader: (2)
The signal strength on a fully functioning camera should go up to about 7 on the Euro 550. If it only goes up to 4 as you pass it, chances are its putting out some dummy radar.
You should be getting a good 200 metres warning of an active camera with the detector beeping at 1 singal strength and increasing to 7,8, or 9 as you pass it.(K band)
Hope this helps, what signal strength are you getting on these cameras.
Beastie
You should be getting a good 200 metres warning of an active camera with the detector beeping at 1 singal strength and increasing to 7,8, or 9 as you pass it.(K band)
Hope this helps, what signal strength are you getting on these cameras.
Beastie
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
55
05 August 2018 07:02 AM
ATWRX
Full Cars Breaking For Spares
88
01 February 2016 07:28 PM