Exhaust & MOT Dilemma
#1
Exhaust & MOT Dilemma
Ive got an Sti RA V Ltd and MOT time is looming but the car has a Scorpion system on it (i think). It was on the car when i bought it and ive come to swap out the centre bit for the catted original (like i used to do with my first scoob and the magnex) but this zorst has no flanges on it - its push fit with clamps on the outside. Bugger!
I dont want to have to lump off the whole system just for the MOT so does anyone know if its either possible to buy a compatible catted centre section or is there somewhere i could get the old catted section modified to fit the scorpion system??? Or is this not possible/a good idea??? Im not an expert on exhausts so any advice would be great!
Ideally if it is possible to get the old centre section modified to slot in somewhere near Yorkshire would be best.
Anyone? Ive had this reminder about MOT popping up for a couple of week now and want to get it sorted redy for the test at the end of the week - if poss. Kicking myself for leaving it late but ive been chocka block.
I dont want to have to lump off the whole system just for the MOT so does anyone know if its either possible to buy a compatible catted centre section or is there somewhere i could get the old catted section modified to fit the scorpion system??? Or is this not possible/a good idea??? Im not an expert on exhausts so any advice would be great!
Ideally if it is possible to get the old centre section modified to slot in somewhere near Yorkshire would be best.
Anyone? Ive had this reminder about MOT popping up for a couple of week now and want to get it sorted redy for the test at the end of the week - if poss. Kicking myself for leaving it late but ive been chocka block.
#2
Originally Posted by Omen
Ive got an Sti RA V Ltd and MOT time is looming but the car has a Scorpion system on it (i think). It was on the car when i bought it and ive come to swap out the centre bit for the catted original (like i used to do with my first scoob and the magnex) but this zorst has no flanges on it - its push fit with clamps on the outside. Bugger!
I dont want to have to lump off the whole system just for the MOT so does anyone know if its either possible to buy a compatible catted centre section or is there somewhere i could get the old catted section modified to fit the scorpion system??? Or is this not possible/a good idea??? Im not an expert on exhausts so any advice would be great!
Ideally if it is possible to get the old centre section modified to slot in somewhere near Yorkshire would be best.
Anyone? Ive had this reminder about MOT popping up for a couple of week now and want to get it sorted redy for the test at the end of the week - if poss. Kicking myself for leaving it late but ive been chocka block.
I dont want to have to lump off the whole system just for the MOT so does anyone know if its either possible to buy a compatible catted centre section or is there somewhere i could get the old catted section modified to fit the scorpion system??? Or is this not possible/a good idea??? Im not an expert on exhausts so any advice would be great!
Ideally if it is possible to get the old centre section modified to slot in somewhere near Yorkshire would be best.
Anyone? Ive had this reminder about MOT popping up for a couple of week now and want to get it sorted redy for the test at the end of the week - if poss. Kicking myself for leaving it late but ive been chocka block.
Thread
Thread Starter
Forum
Replies
Last Post
fatboy_coach
General Technical
15
18 June 2016 03:48 PM