Ciggy lighter
#1
Mines packed up and I think a wire may have come adrift. Anyone know if it can be pulled out from the front or do you have to access it from behind via the hifi aperture.
Thanks
Russell
[This message has been edited by russell hayward (edited 22 August 2000).]
Thanks
Russell
[This message has been edited by russell hayward (edited 22 August 2000).]
#4
If I remember rightly you have to TEASE the console surround away (use a screwdriver and cloth/card to protect surround) which leaves stereo intact, ashtray and lighter come away with surround
Harry
MY99
Harry
MY99
#6
If it is dead and you can't find any blown fuses it may be the fusible link on the back of the *** lighter socket. You need to pull off the centre console trim around the gear lever (just pull up the front bit with the gaiter- hand in the gaiter hole, sounds australian?) and then once this is twisted out of the way you need to grit your teeth and remove the thin plasticy centre dash surround which the *** lighter is attached to. All I can say is just pull but try and get your hands on the strong bits - if you can find any. That bit requires nerves of steel There is a little link thing on the back of the lighter socket which will need replacing - I just used some fuse wire as a temporary bodge.
Moral - don't try and use a 12v car kettle.
Moral - don't try and use a 12v car kettle.
Trending Topics
#8
Thanks for your help everyone.I'm sure the thing is absolutely dead although the "light" around it still works I didnt realise the cemter console bit just pulled away, and will try this at the weekend.
Thanks again..
Thanks again..
#9
My centre console panel needed to be refitted yesterday and I took it to Subaru to sort it out. They did the job as I watched and thay pointed out how the problem occurs.
The console is held in place with 4 spring clips. It seems that the clips ping off when you remove the unit and disappear never to be seen again. Therefore, take great care when removing it.
They removed the arm rest and gear lever surround first and this is just a couple of screws.
Hope this helps.
The console is held in place with 4 spring clips. It seems that the clips ping off when you remove the unit and disappear never to be seen again. Therefore, take great care when removing it.
They removed the arm rest and gear lever surround first and this is just a couple of screws.
Hope this helps.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
38
17 July 2016 10:43 PM
MeisterR
Car Parts For Sale
1
15 September 2015 07:07 PM