How can I check if its been re-mapped????
06 February 2004, 01:41 PM
#1
Scooby Newbie
Thread Starter
Join Date: Feb 2004
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
How can I check if its been re-mapped????
After Having an STi engine fitted into MY99 WRX I also paid to have the ECU re-mapped...
...However it seem to drive exactly the same
I was originally told I could probanly get away with a Tec 1 re-map which wouldn't give any more power but would make the car safer (ie no DET).
However I was then told that it had needed a full Re-map as it had previously been mapped with a RA map, which would make it run too lean hence the DET & Blown engines...
So they have now told me it has a P1 Map.
Is there anyway I can check or am I getting spoon fed BULL SH*T?
...However it seem to drive exactly the same
I was originally told I could probanly get away with a Tec 1 re-map which wouldn't give any more power but would make the car safer (ie no DET).
However I was then told that it had needed a full Re-map as it had previously been mapped with a RA map, which would make it run too lean hence the DET & Blown engines...
So they have now told me it has a P1 Map.
Is there anyway I can check or am I getting spoon fed BULL SH*T?
06 February 2004, 02:09 PM
#2
Scooby Regular
Join Date: Jan 2003
Location: 535D M-Sport Touring
Posts: 3,190
Likes: 0
Received 0 Likes
on
0 Posts
Difficult to say. The obvious thing would be the different boost levels between maps. Are you getting a higher / lower boost reading since the remap (assuming you have a boost guage). If you have a AFR guage is is now reading richer on WOT?
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
toyney83
General Technical
10
02 October 2015 08:38 PM