Paulo P

iTrader: (42)

Hi All

I went to change the steering wheel on my sisters scoob the other day to a Nardi without an airbag. I took the old wheel off though and noticed that you need a different ring for the horn so I had to put the wheel back on.

Now the airbag light is on I have tried an ECU reset but that did **** all

How are you supposed to fix this after removing the wheel?

Thanks in advance

Paul

talizman

iTrader: (1)

Take the bulb out!

Seriously though, I did this on an old car and when I traded it in, the light was on, and I believe the garage had to run some sort of diagnostic on it to tell the ECU that the circuit was in fact complete and put the light off.

Paulo P

iTrader: (42)

talizman

Great minds think alike I was going to do this but couldn't get the dash out so I took the clear cover off and put a bit of black insulating tape over it instead You can't even see the tape unless you look but I wanted to know if you could do it properly.

Thanks

p.s <note to self> never buy one of talizman's old cars </note to self>

[Edited by paulpalmer - 11/24/2003 12:00:30 PM]

dnb

The airbag lamp has it's own little connector on the back of the dash. (At least on pre MY98 Scoobs)

Need I say more?

talizman

iTrader: (1)

lol @ paulpalmer

Paulo P

iTrader: (42)

dnb

I will have to try and remove the dash then

Paul

Paulo P

iTrader: (42)