Servicing a Forge VTA dv on a MY00
13 October 2003, 03:23 PM
#1
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Jan 2003
Location: Lofty in Hull
Posts: 1,587
Likes: 0
Received 0 Likes
on
0 Posts
I have the full kit - 4 springs, 3 shims, 2 seals, grease etc.
But how do I do it?? Any links to a site with instructions/piccies would be much appreciated.
Whilst we're on the subject, how do I know that it's working properly once done?
TIA,
Steve
But how do I do it?? Any links to a site with instructions/piccies would be much appreciated.
Whilst we're on the subject, how do I know that it's working properly once done?
TIA,
Steve
13 October 2003, 04:27 PM
#2
Scooby Regular
iTrader: (1)
Join Date: Apr 2003
Location: Glasgow, Scotland
Posts: 5,947
Likes: 0
Received 0 Likes
on
0 Posts
I spoke with Forge re this last week and they stated that unless it is leaking, they do not recommend stripping it down.
Give them a phone if you are determined though... most helpful.
Give them a phone if you are determined though... most helpful.
Thread
Thread Starter
Forum
Replies
Last Post