Andy555

I know its been done to the death, but I am not sure if I have the sensor in the best position. It is placed on the nearside side of the manifold.

I have tapped the manifold quite hard with a socket in the centre of the manifold, and ir barely lights up, even though you can hear the tap from inside the car, tapping the opposite side of the manifold hard does not register at all.

I am now thinking that the sensor may not be picking up all knock. I have searched and seen some interesting info on where to put it, I have had a look at my STI 1996 and cannot see the same threaded holes (ie below intercooler), if anyone has any info or even hands on help, It would be much appreciated.

I have also tried to put the sensor under the I/C near the earth wire position, just to the front a bit, there is a thread hole. Does anyone know what size bolt will be needed, I did not take the I/C off, but tried to get an M8 40 mm in and it does not seem the correct size, anyone know???? Any Info?

Jake

Your welcome to have a look at mine if you like, I am only down the road from you.

Infact I am just about to go up your road to spend some beer tokens!!

Andy555

I would appreaciate that Jake, if you are free tomorrow let me know your address, I think you are just opposite Tescos in the Posh bit?

Much appreciated if I can, cheers Jake

Jake

YHM

Dyney

Fitted one today and cut down a M8x40 bolt to about 35mm.