Quick Question
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Jul 2001
Posts: 1,052
Likes: 0
Received 0 Likes
on
0 Posts
i posted this in the scottish forum, they normally help but its a bit dead tonight...
I got my car (supraTT) back from the garage today (blown turbos)
All seemed fine..... got away from the garage, gave it a boot full, no 2nd turbo just caries on with the acceleration from the 1st
Any ideas.....???
Its going back in tomorrow for a service, so i'll get them to investigate...... thought they would have noticed this on the testdrive tho
The idle is also alot lower and quite lumpy
(sounds like a disconnected or wrongly connected hose to me)
The exhaust blades and shaft were missing on No1 That was my problem
I'll get pics of them tomorrow
I got my car (supraTT) back from the garage today (blown turbos)
All seemed fine..... got away from the garage, gave it a boot full, no 2nd turbo just caries on with the acceleration from the 1st
Any ideas.....???
Its going back in tomorrow for a service, so i'll get them to investigate...... thought they would have noticed this on the testdrive tho
The idle is also alot lower and quite lumpy
(sounds like a disconnected or wrongly connected hose to me)
The exhaust blades and shaft were missing on No1 That was my problem
I'll get pics of them tomorrow
#2
my best mate has exactly the same problem. no1 turbo blown, no2 turbo with blades destroyed. the car was reaching only 0.3 bar. he is planning to put hybrids now with 1500 quid. and he is going to set them to work at the same time not sequentially. more reliable this way.
#3
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Jul 2001
Posts: 1,052
Likes: 0
Received 0 Likes
on
0 Posts
these are my replacement turbos!! fitted yeasterday/today It boosts up fine on no1 but doesnt seem to even try and get 2 going.... no drop in pressure etc
My exhaust side on no1 was missing poor bugger behind me!
My exhaust side on no1 was missing poor bugger behind me!
#4
go asap to the guy that did the job, he didn't test drive the car????????? he is supposed to make sure that what he did was right
[Edited by scooby_xt_turbo - 9/17/2002 11:44:53 PM]
[Edited by scooby_xt_turbo - 9/17/2002 11:44:53 PM]
Thread
Thread Starter
Forum
Replies
Last Post
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM