Hi can some one help me I need to get the longer inlet bolts for my 95 Sti as I am fiting my spacers and have lost my bolts like a ---- thanks

 

No one out ther can help me then

 

Im in the middle of this too at the moment, take it you dont have a fastner or bolting place nearby? Advance automotive or roger clark have them on the shelf roughly 28 quid. Im getting from my local place as theyre just cap screw replacements

 

28 Quid?????????????????????????????????????????????? ???

I got some from my local hardware store for about 50p each.

 

Dame it well you don't have the size of the ones you got do you mate

 

Think I have a box with spacers & bolts in lock up
If your not sorted by / I can dig them out & measure for you , but it will be Saturday / I'll keep a eye on thread if all else fails happy to help ..

 

I'm under the impression these bolts are M10 fine thread (measure up one of yours to be sure). Can't you just get some off ebay that are the original length + the thickness of the spacer?

Also, if the spacer isn't super thick, you'd probably get away with the original bolts tbh - you don't need to have the bolts protrude 2cm into the block or anything, unless you go gorilla on the torque

 

I have the advance automotive kit and the bolts were too long. Had to cut them down

 

I used bolts I had in my garage. They're not an unusual thread. You could get them from B&Q for less than £28

 

Sorry no idea but I think they were standard M8 just a cm or so longer than the originals.

 

I measured the bolts for you
On the Grimm speed 8mm phenolic spacer kit
P/N 019001
The bolts are exactly 100mm in lenth

Regards