engine and turbo risk
05 January 2016, 07:17 AM
#1
Scooby Regular
Thread Starter
iTrader: (3)
Join Date: Oct 2004
Location: South Wales
Posts: 185
Likes: 0
Received 0 Likes
on
0 Posts
engine and turbo risk
Hi all, i have an uk sti blob wide track with ppp psckage. In an few weeks im going to get my car mapped. Is it ok if i fit the the following:
1. Rcm induction kit
2. Perrrin 3 port boost solenoid
3. Perrin 4 bar map sensor
4. Gt spec manifold
Will it be ok to run these mods for an few weeks before the map session?
Will i be at high risk of my engine or turbo failure? Because it will be running to rich or lean.
Thanks for your input all.
1. Rcm induction kit
2. Perrrin 3 port boost solenoid
3. Perrin 4 bar map sensor
4. Gt spec manifold
Will it be ok to run these mods for an few weeks before the map session?
Will i be at high risk of my engine or turbo failure? Because it will be running to rich or lean.
Thanks for your input all.
05 January 2016, 07:30 AM
#2
Scooby Regular
I'd put the headers on and the induction kit and leave the other two till map day to be honest as it won't take long or just put the headers on and leave rest till map day let us know your results before and after
headers will probably put the car in limp mode so you'll be ok on the safety side of things but leave the sensors
headers will probably put the car in limp mode so you'll be ok on the safety side of things but leave the sensors
Thread
Thread Starter
Forum
Replies
Last Post
S555 MKR
Subaru
5
06 December 2015 06:37 PM