Milltek Gasket size
#1
Milltek Gasket size
Afternoon all,
Can someone point me in the direction of the correct size gaskets for a milltek cat back, I'm afraid I don't have a part numbers as the goods are in transit and used. It's the same as the cat back package listed for below..
http://www.scoobyworld.co.uk/catalog...oducts_id=1832
I've spoken to milltek and Scoobyworld and they are both unable to help as one needs part numbers and the other doesn't stock them.
Just to mention also, my current system is a full 2.5. I'm guessing the middle section tapers internally down to a 2.5 from 2.75 to allow people to connect them to the OEM 2.5?
Cheers.
Can someone point me in the direction of the correct size gaskets for a milltek cat back, I'm afraid I don't have a part numbers as the goods are in transit and used. It's the same as the cat back package listed for below..
http://www.scoobyworld.co.uk/catalog...oducts_id=1832
I've spoken to milltek and Scoobyworld and they are both unable to help as one needs part numbers and the other doesn't stock them.
Just to mention also, my current system is a full 2.5. I'm guessing the middle section tapers internally down to a 2.5 from 2.75 to allow people to connect them to the OEM 2.5?
Cheers.
Last edited by Kedlestone; 10 April 2014 at 02:31 PM.
#2
Scooby Regular
iTrader: (23)
Possibly not a straight fit milteks can be a strange fitment, I had a flange cut off and rotated to suit my decat as when in position the holes didn't line up as the Miltek flange was offset, They do a 2.75" and a 3" system so gasket to suit depending on bore size, just to mention I think someone used to sell a reducer to fit to a 2.5 but can't remember who
#3
I spoke to a chap at litchfield who seem to think they were a straight fit if it was just a cat back 2.75...I've seen a few companies that do reducers, pretty certain I've got the 2.75 version going by the pictures I got sent. When I turns up I'll have to give it another measure and see what's what, just wanted to order the new gaskets ready for fitting.
Cheers though.
Cheers though.
Thread
Thread Starter
Forum
Replies
Last Post