Oil squirters clearence problem!
#1
Scooby Regular
Thread Starter
iTrader: (3)
Join Date: Feb 2009
Location: Rotherham, South Yorkshire
Posts: 79
Likes: 0
Received 0 Likes
on
0 Posts
Oil squirters clearence problem!
Hi guys, was hoping somebody could shine a little light on my problem. I've got a 2.0 cdb and a cosworth stroker kit, I've just done a dummy build and found the piston hits the oil squirter! I'd rather not have the piston ground or remove the squirters is it possible to sit them down further into the block? Any ideas or suggestions please?
#2
Scooby Regular
iTrader: (22)
Had this on my CDB build.
You have three options.
1, Machine the pistons,
2, Machine the block to sit the squirters lower
3, lose the squirters altogether and cap of the holes for them.
I, Like a few others chose option one.
These are taken from Andy's build who had the same issue on his.
You have three options.
1, Machine the pistons,
2, Machine the block to sit the squirters lower
3, lose the squirters altogether and cap of the holes for them.
I, Like a few others chose option one.
These are taken from Andy's build who had the same issue on his.
Thread
Thread Starter
Forum
Replies
Last Post