DIY FMIC - Turning around the manifold
#1
it was previously discussed about turning the manifold round on a 93 WRX and it was decided the throttle bodie sits to high. instead of re-fabricating the manifold i have just had a though to another idea.
would there be any reason why an adaptor plate shaped like a wedge could not be inserted between the body and manifold (see picture).
personally i cannot see any problems except some minor cable adjustments.
any thoughts on this?
would there be any reason why an adaptor plate shaped like a wedge could not be inserted between the body and manifold (see picture).
personally i cannot see any problems except some minor cable adjustments.
any thoughts on this?
Thread
Thread Starter
Forum
Replies
Last Post