The time has come to part with my Subaru either as a whole or in bits
To give the car its proper title it is a Subaru Impreza WRX STI Version 6 Type RA WRL Ltd Edition number 522, there were only 2000 ever made and very few in this country and even less with this spec.
Being the RA it has the limited edition blue trim parts, adjustable diff (DCCD Type 180), roof vent etc…

This car has had a lot of mods over the years to make it quicker, more reliable and very much fun to drive.

As many of you will probably know I had my can on ebay however it didn’t quite reach reserve tonight, it came close though so I am gauging your interests if I was to break. Below is a list of parts and prices of which I think I’ve been fair ?
Please note the car will not be broken until a deposit is taken for the engine and the gearbox as test drives could be needed.

Original RA Roof vent & Fittings £250
Later engine with new V9 nitrated crank £2100
Spec C Bearings + Rods, Forged Pistons
R.C.M.S Oil pump
R.C.M.S Light weight flywheel & AP Racing paddle clutch £250
740cc Nismo Injectors £200
R.C.M.S Garret GT30/40 Hybrid Turbo £500
HKS Front Mount Intercooler £250
Blitz Dump valve £80
Samco 100mm Induction Hose £80
Silicone blue Water/Volume hoses £30 SOLD
R.C.M.S large alloy K&N Induction Filter £100
A.R.C High capacity Gull wing sump £200
Group N engine & gearbox mounts £50
Tommie Extreme 3 bolt Headers and Up pipe £250
3 inch HKS Down pipe £100
True 3 inch Exhaust front to back and x2 slip on back boxes, one quiet & one noisy? £150
Aluminium thick racing radiator £60 SOLD
Port & Apexi AVCR Boost controller £200
Possum Bourne/Link engine management & Data link/Cable/Software £250
754 Casing DCCD PPG Straight Cut gearbox with Billet selectors and a UK 5 £2250
Type 180 Plated Diff £300
Defi gauges Inc Exhaust gas Temp, Fuel Pressure,
2 bar boost gauge, Water temp, Oil Temp & Oil pressure £800

Lambda Link & Knock Link £110
Bosch 044 Fuel Pump/swirl pot set up £80
Fuel Lab regulator £150
Flocked Dash £85
AP Racing 6 pots and 330mm Discs, good Ferodo DS2500 pads all round £1100
18 inch Tarmac Alloys & fresh Prada Tyres £350
Carbon WRC Mirrors £120
Tein Coilovers adjustable all round £300
Cusco Roll cage £300
Bonnet lifters £50
STI Rear lights £150
Original rear STI V6 spoiler £150
Quick rack complete with pump/pipes £250
Oil Catch can & piping £45
Interior (WRC LTD EDITION Blue front seats/black rear seats + Matching black door cards) £300
WRC LTD EDITION V6 dash pod with dccd display £80
DCCD Thumb wheel control switch £40
Folding STI V6 Mirrors £60

CDF Blue Lightened Pulleys £85
2 pot rears calipers & discs complete with Ferodo DS2500 pads £200
LTD Edition WRC Number 522 version 6 STI RA Shell £1800
Type 180 rear hubs and driveshafts £150

As many of you already know I was hoping for £10,000 for my car complete as I think I have priced fairly considering the spec.
If anyone is interested in the car complete please PM me ASAP and I can give you more details re Mot & tax etc

There is at the minute two bog standard Ltd Edition ones on Piston Heads (fresh Imports) for £8500
The car itself is in very good condition and the paint gleams. There is a small dent in the boot that I have been quoted £75 to get repaired to remove, I just never got round to it as its not that bad, a scuff to the bumper and the normal Impreza stone chips, I’m just being honest but it wouldn’t take much to get this car to show standards.. I’m sure there is loads I have missed off but if you have any questions please just pm me but please be patient as I am at work all day so will answer when I get home which can be late some nights.

 

1st dibs on 044 and swirl pot setup,
Alloy rad.

 

any pics of coilovers and exhausts plz.thanks

 

1st dibs on Sump please.....

 

ill take the fuellab fpr pls.

 

1st dibs on nismo 740cc injectors please, cash waiting for you!

 

If you can send me a picture of rear brakes may have them aswell!

 

first dibs on turbo please

 

Luke, would your pulleys fit mine? As you know interested in FMIC, would the dash fit mine, also interested in the rear brakes if they fit

 

thanks for the interest chaps all noted down, as soon as i have interest in the engine i will break the car in a weekend and sort it all out!

david not sure mate look into it and let me know,let me know about the front mount aswell as the other bits! engine would go well in yours with your choice of turbo sure i could sort the fitting out lol

 

Exhaust please mate

If Hull STi dosnt want

 

If I could I would, well if I could, I would have the whole car!

 

I might need the power steering hose if you break it

 

interested in the rad and light weight pulleys and lamba and knock link mate

 

Hi mate where are you based?

 

1st dibs on sti rear lights please

 

I willtake the 044 if hardy doesn't take it

 

Carbon WRC Mirrors £120

First dibs please

 

Hi mate,

I'm interested on those:
Bonnet lifters £50
Silicone blue Water/Volume hoses £30 (how many miles on the car?)
Aluminium thick racing radiator £60 (what brand? how many miles?)
3 Port & Apexi AVCR Boost controller £200 (is it the black edition?)
Interior black rear seats + Matching black door cards. What is the price for those only?

Also, will you post the items to Greece?
Can you please ask for a price quote for shipping the rear seats and the black door cards?

 

Lambda Link & Knock Link £110 - Are these not seperate units? I was after a knock link to keep an eye on det

 

Could I stick my name down for the rear hubs and shafts please.

2nd dibs on the turbo if Mr Drifter above does not want it

 

Can I have the wheels if you break it.

 

1st dibs on rear spoiler if u can post

 

Ill take the engine and gearbox mounts.

 

ill have the exhaust just want a pic of it to see what its like.thanks

 

1st dibs on quick rack, im in andover so can pick up

 

Hey mate would be very interested in the Link ecu, is it plug in or wire in? I have a version 3 sti import. Let me know cheers mate.

 

hello all sorry for the late reply long day lol, there seems to be worth while interest in breaking the car so thats the route i will take, over the next couple of days i will get a proper advert up for the engine and ppg gearbox hope fully get that sold asap then i can break the car in one weekend no problem,i have kept a note of who wants or has shown interest in bits and pm's and will then contact those people with pictures if asked for etc, cheers luke

 

Hi mate, what would come with the shell for £1800?
PM me if u like

 

all pm's replied to