Big power twisted turbo set up with up pipe and down pipe with full length wastegate runner. All DEI heat wrapped.
Running in on a 2 litre this was doing an easy 460 bhp.
Ideal for a torquey 2.5 litre set up. £650.

 

what is the turbo and
will this fit on a newage ej257 conversion?

 

It is an Ion turbo imported from Canada and it will bolt on to just about anything.

 

hi harvey i could very well be interested in this bud. i think you know my cousin ste and his dad graham. darren at dlm fitted my engine last year for me. i have an ej257 goin for a simtek in a couple of months just runnin new internals in. is it a direct replacement or a twisted setup required?

many thanks lee (darlington North road)

 

just noticed on your post its twisted. would it fit direct bolt on? if not what else would i need? thanks

 

This turbo will be well suited to a 2.5 litre and will develop lots of torque.
It comes with a twin dump downpipe, specially fabricated and already heat wrapped and this will bolt straight on to almost all exhaust centre pipes. As with the up-pipe this will bolt straight on to either O/E headers which ideally will be ported or better still tubular TWO bolt flange headers.
BTW I also have a set of new 2 bolt flange GT Spec tubular headers, ported and ceramic coated.
Come and see the kit in the flesh if you wish.
harveysmith1@btopenworld.com

 

Bttt:///

 

bttt.///

 

bttt.///

 

would a gt30r/ gt35r fit these pipes?. Also does the turbo provide need an external wastegate?

 

The pipes are for sale with this turbo only. This turbo has an internal wastegate and as you will see from the downpipe the wastegate section which is completely separate does not join the main exhaust downpipe until close to the end of the actual downpipe itself.

 

bttt.///

 

will this be a direct fit my vesion 2 sti, its running a 3inch exhaust straight throuh, or will i need to buy other parts as well thanks

 

This fitted straight on to an STi 6 so it will match up with the headers and exhaust system of any Classic Subaru with minor modification, if any.
You will need an inlet system. I used a straight bit of silicon and large cone with trumpet.

 

Is it a 2.5 or 3" exhaust outlet?

 

3"

 

Looks good Harvey, free bump for ya

 

SOLD Subject to funds Friday evening.

 

SOLD