Corvette problem
03 December 2004, 03:22 PM
#1
Corvette problem
A mate of mine recently bought a 89 Vette, he took it out today and had a 'mishap', he booted it on a wet road and it nearly spun but he managed to correct it, I dont think it was heroic driving skill, I think the kerb helped a bit....
Therefore, has anyone any experience of Vette's or know any UK boards where he could source some bits, appraently the rear nearside wheel is scrap and is sat at an unusual angle.
Any suggestions gratefully received.
Therefore, has anyone any experience of Vette's or know any UK boards where he could source some bits, appraently the rear nearside wheel is scrap and is sat at an unusual angle.
Any suggestions gratefully received.
03 December 2004, 03:26 PM
#2
Scooby Newbie
Join Date: Nov 2004
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
http://www.corvetteuk.com/
yep try scott at corvette kingdom...http://www.corvetteuk.com/u will need all the details before calling ie exact model chassis etc and what u need!
05 December 2004, 12:46 PM
#3
Scooby Senior
Join Date: Nov 2001
Location: West Yorks.
Posts: 4,130
Likes: 0
Received 0 Likes
on
0 Posts
My dad used to run a '75 350 cu in 'Vette and was a member of the Classic Corvette Club so their site would be worth checking out :
http://www.corvetteclub.org.uk/
They are absolutely bloody lethal in the wet, and not much good round corners for the inexperienced driver so tell him to be careful !!
http://www.corvetteclub.org.uk/
They are absolutely bloody lethal in the wet, and not much good round corners for the inexperienced driver so tell him to be careful !!
Thread
Thread Starter
Forum
Replies
Last Post