EP-8KHA+ Motherboard Question!
#1
A mate of mine has just recently purchased a Socket A(EP-8KHA+)Motherboard and asked me if i knew what the FF stood for on the LCD display type thing on the board! Being that i havnt a clue what hes talking about,does anyone else know?
Nick Y
[Edited by Nick Young - 12/23/2001 10:00:31 AM]
Nick Y
[Edited by Nick Young - 12/23/2001 10:00:31 AM]
#2
Scooby Senior
Epox boards have two lcds that display boot progress. If the boot fails you can tell where the problem lies. FF just means that the boot/post was successful and control has been handed over to the operating system.
#3
They are LED's not LCD's
FF signifies a boot attempt (INT 19h). I'm pretty sure on my 8kha+ that this value changes as the PC starts running. At the front of the manual there is a small FAQ and it would appear that if the display continuously displays FFh then there is a problem:
1. BIOS chip replace inverse
2. Update wrong bios
3. Mainboard problem
4. ADD-ON Card insert inappropriate.
(as printed in the manual - not my dodgy english)
I would suspect he hasnt seated his memory correctly, as this seems a common problem. I would remove all uneccessary hardware and start from scratch to get it to boot.
The manual has a list of post codes for the LED's and they can also be obtained from http://www.epox.com/html/english/sup...p?Article=1544
[Edited by howardb - 12/23/2001 11:30:51 AM]
FF signifies a boot attempt (INT 19h). I'm pretty sure on my 8kha+ that this value changes as the PC starts running. At the front of the manual there is a small FAQ and it would appear that if the display continuously displays FFh then there is a problem:
1. BIOS chip replace inverse
2. Update wrong bios
3. Mainboard problem
4. ADD-ON Card insert inappropriate.
(as printed in the manual - not my dodgy english)
I would suspect he hasnt seated his memory correctly, as this seems a common problem. I would remove all uneccessary hardware and start from scratch to get it to boot.
The manual has a list of post codes for the LED's and they can also be obtained from http://www.epox.com/html/english/sup...p?Article=1544
[Edited by howardb - 12/23/2001 11:30:51 AM]
#4
Howardb,
Sorry my friend i meant LED's,however he has used that site and the board is displaying FF not FFh!
Nick Y
Forgot to say!Thanx XRS for the reply!
[Edited by Nick Young - 12/23/2001 12:09:12 PM]
Sorry my friend i meant LED's,however he has used that site and the board is displaying FF not FFh!
Nick Y
Forgot to say!Thanx XRS for the reply!
[Edited by Nick Young - 12/23/2001 12:09:12 PM]
Thread
Thread Starter
Forum
Replies
Last Post
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM