How are (Vicers) Hardness and Tensile strength related in steel?
#1
Scooby Regular
Thread Starter
Join Date: Jun 2001
Location: Sheffield / North Wales
Posts: 1,165
Likes: 0
Received 0 Likes
on
0 Posts
How are (Vicers) Hardness and Tensile strength related in steel?
I've been told that it's a general rule of thumb that tensile strength (in MPa) is 3 times the value for Vicers hardness HV. The example used is a mild steel with hardness ~100Hv. Can anyone confirm that this is correct? I can't find any reference to this rule of thumb in text books or online.
Cheers,
Ben
Cheers,
Ben
#2
Scooby Senior
Join Date: Nov 2001
Location: West Yorks.
Posts: 4,130
Likes: 0
Received 0 Likes
on
0 Posts
#3
Scooby Regular
Join Date: Sep 2002
Location: The biosphere
Posts: 7,824
Likes: 0
Received 0 Likes
on
0 Posts
It would vary quite a bit depending on the material, but I found this approximation for steel and Brinell Hardness:-
Since we are being quite approximate here the Vickers hardness tends to come out slightly larger than Brinell so around 3 (ish) would seem reasonable for steel at least.
If safety is a factor I wouldn't like to rely on it for other materials though!
Since we are being quite approximate here the Vickers hardness tends to come out slightly larger than Brinell so around 3 (ish) would seem reasonable for steel at least.
If safety is a factor I wouldn't like to rely on it for other materials though!
Last edited by ajm; 21 April 2004 at 07:39 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Pro-Line Motorsport
Car Parts For Sale
2
29 September 2015 07:36 PM