petethemeat

iTrader: (6)

As above, I am toying with locations of where to fit my new gauge.

I have discounted the clock area (only have 1 gauge) and A pillar (not keen on that look)

I am also considering a single dash pod tucked in the drivers side of the dashboard (aswell as in the air vent). I would be interested to see who is running this setup & how it looks.

Thanks

Finbin

Hi

I am also looking at fitting a single gauge to MY00. I am searching for a good looking one, I don’t like the A pillar types.

Found this one:-
http://www.scoobyworld.co.uk/catalog...oducts_id=1205

Don’t like the screw fitting.

This one looks better, but not going to pay over £50 for it

http://www.ebay.co.uk/itm/Subaru-For...item19c79a4961

I am sure I have seen one that fits in the right-hand corner of the windscreen, but I can’t find any yet.

Is there any body that can help?

F1 CJE UK

iTrader: (8)

sorry its a A pillar type but it gives you an idea of what it looks like

rickya

iTrader: (18)

Im now in similar position after just buying the Depo 4in1 gauge. May put into drivers side vent but thats almost hidden by the steering wheel & arm while driving. Rather have it more in my eyeline, either on dash somewhere or on steering column. A few fitment ideas but not sure on placement yet.

http://www.ebay.co.uk/itm/1809162157...#ht_2095wt_845

http://www.ebay.co.uk/itm/1202969094...84.m1423.l2648

Or below I prefer this to A pillar pods

http://www.etsracing.com/Page5.html

JonMc

iTrader: (51)

The first and last look a bit ropey in terms of fitment. The autobahn one doesn't look too bad if fitted properly; Jura used to have them before we fitted his A-pillar.

Other option could be one like this

http://www.ebay.co.uk/itm/ATI-ATI-25...item1c1d8ea9d0

rickya

iTrader: (18)

Too expensive and Iv only got 1 gauge!

Your right John, how will those pods be fitted, - black silicone sealant or something?
Il have to offer it up around the dash area and see where it looks / fits best and then accordingly look for a suitable pod.

JonMc

iTrader: (51)

I'd put money on the being supplied with double sided stick pads

Buy more gauges

steviefastbikes

You could use half the centre vent. Just fiberglass and p40 needed to build. I have made afew . Very stealth.

rickya

iTrader: (18)

Any pics mate?

JonMc

iTrader: (51)

I could build that for you, I have the stuff in the garage and when I get the new electric spray gun I could plasti-dip the dash for you

steviefastbikes

Sorry bud they were done by me for friends never took pics.

steviefastbikes

John weekend after is good...
Sorry for wee hijack

JonMc

iTrader: (51)

No worries mate, I'll PM you my mobile number - what other parts should I get - oil seal, roll pin...

winston69

iTrader: (30)

https://www.scoobynet.com/showpost.p...&postcount=583