Went to Power Engineering today
#1
Went to Power Engineering today
We went down Power Engineering today to see their new dyno in action and to get a few power runs
Neil’s car
It made 545bhp with an exhaust blow, should have been more but Iain thought it felt short of ignition timing.
Cliff’s car
Cliff’s car was suffering some detonation so Iain aborted the run
Mine
The figures for mine? I was expecting around 260bhp and 310lb/ft
Ignore the boost figure, unless the gauge is massively wrong in the car it was 1.2 bar
Well chuffed with those results and love the fact that you can get low cars on and off the dyno without issue because it is sunk into the ground.
Thanks Iain for the power runs
Neil’s car
It made 545bhp with an exhaust blow, should have been more but Iain thought it felt short of ignition timing.
Cliff’s car
Cliff’s car was suffering some detonation so Iain aborted the run
Mine
The figures for mine? I was expecting around 260bhp and 310lb/ft
Ignore the boost figure, unless the gauge is massively wrong in the car it was 1.2 bar
Well chuffed with those results and love the fact that you can get low cars on and off the dyno without issue because it is sunk into the ground.
Thanks Iain for the power runs
Thread
Thread Starter
Forum
Replies
Last Post
Wingnuttzz
Member's Gallery
30
26 April 2022 11:15 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
38
17 July 2016 10:43 PM