PSI3 Unit Faceplate
#1
PSI3 Unit Faceplate
I've not been able to fit my PSI3 data monitor I've had for a while now, because the faceplate was in terrible condition.
Simon@psi3 is looking into it, but he thinks he's thrown out the ones for my model a while back.
So I was toying with the idea of making my own. Just by printing off on photopaper for now, but ideally I'd like it done on carbon fibre sheet. My inkjet won't print onto that, I would imaging, and I know it doesn't have white ink.
Come up with this so far:
If anyone would like to play around with it or use it feel free. If anyone could put a carbon fibre backgroung in it that would be great too.
Its for the classic top pod BTW.
Simon@psi3 is looking into it, but he thinks he's thrown out the ones for my model a while back.
So I was toying with the idea of making my own. Just by printing off on photopaper for now, but ideally I'd like it done on carbon fibre sheet. My inkjet won't print onto that, I would imaging, and I know it doesn't have white ink.
Come up with this so far:
If anyone would like to play around with it or use it feel free. If anyone could put a carbon fibre backgroung in it that would be great too.
Its for the classic top pod BTW.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM