ooopsy
19 September 2014, 04:11 PM
#1
Scooby Regular
Thread Starter
iTrader: (8)
Join Date: Dec 2009
Posts: 783
Likes: 0
Received 0 Likes
on
0 Posts
ooopsy
Just brought the misses a Blob eye... :-)
first job was to remove stickers as not my cupa tea. Then brought a prodrive back box and installed it. Next month or so engine will be out to fit the new clutch.. actually looking forward to pulling the engine out.. strangely..
first job was to remove stickers as not my cupa tea. Then brought a prodrive back box and installed it. Next month or so engine will be out to fit the new clutch.. actually looking forward to pulling the engine out.. strangely..
keeping this one simple mate?
.SJ.
19 September 2014, 04:57 PM
#5
Scooby Regular
Thread Starter
iTrader: (8)
Join Date: Dec 2009
Posts: 783
Likes: 0
Received 0 Likes
on
0 Posts
Nothing big on this one as only a GX, although as i like to tinker i have been looking at STI engines, even debating on putting my engine in there when i start building my next engine.. :-)
Indeed mate, was pulling them off when it was put on the back of the flat bed.
Ha ha ha Me too SJ, have had a few options to swap mine for a Blob but just can not do it.
Got some more bits for mine as well so will be posting up at some point on my project.
Indeed mate, was pulling them off when it was put on the back of the flat bed.
Ha ha ha Me too SJ, have had a few options to swap mine for a Blob but just can not do it.
Got some more bits for mine as well so will be posting up at some point on my project.
Thread
Thread Starter
Forum
Replies
Last Post