hi ,am planning to swap the swooch boost gauge for the prosprt stepper version just trying to find out are the wires same or similar
for the prosport fitment? its the stepper type with peak reading that's been installed. any thoughts welcome.

 

usually has 2 lives, one permanent (red) and one ignition (yellow)

orange and white for illumination and black is for earth

 

chears tubby , I guess when I get the screw driver out and other gauge turns up I will see like for like , but im betting the wires wont be a simple pull that out and push that in there. best get the elec tester out as well. thanks for your advice.

 

prosport steppers have two loom, each on a multiplug.

one for the power etc, the other for the sender

 

yes looking at the pics on google the rear has got 2 sockets, should be fun! mind u I can always stick the swooch back in if I get any problem. should be ok , I hope