Dave uk blue mica

Hi I've got a 1999 uk impreza turbo that I'm converting to a dccd set up, the dccd stuff I have is from a version 3/4 but the clocks I need are from a version 5, I'm wondering how to get the dccd lights working if its possible to do with the version 3/4 stuff I have or do I need a dccd ecu and wiring off a version 5 car to get the dccd lights working in the clocks? Anyone any ideas?

trails

iTrader: (41)

Dave, I've done a full DCCD swap on my v6 wagon; all the OE kit, thumb wheel, ECU, clocks and loom. have a wade through my project thread, it is possible but it's a 'nut deep' type exercise

DCCD was on a separate loom up until v5/6 at which point it gets bundled into the main loom. The connectors are different too, there is a v5\6 DCCD wiring diagram on my thread too

Dave uk blue mica

So did you use the complete loom or strip the loom to get the dccd part of the loom out of the main loom? I've got the loom for a version 3/4 and the thumb wheel and ecu etc so the dccd will work off that but I fancied fitting the dccd clocks too so it would all look oem then

trails

iTrader: (41)

Exactly as you describe...not tested it yet though!?

Dave uk blue mica

Have you got a link to your project page? I can't seem to find it!

trails

iTrader: (41)

https://www.scoobynet.com/projects-4...on-fettle.html

it's quite long...probably the stuff from last spring onwards will be most helpful

Dave uk blue mica

Found it! Think I'll need to try and get a version 5 dccd wiring loom!

Dave uk blue mica

Bought a version 6 sti ra dccd module and dash loom now anyway so that should hopefully get my version 5 dccd clocks working!

trails

iTrader: (41)

good luck...let me know if I can help

Dave uk blue mica

Ok excellent thanks