I have fitted a set of Hawkeye clocks to my JDM Blob so as to get the speedometer converted to Kph.

Two of the plugs fitted fine but the third on the left side of the dash that works the fuel DCCD etc. had to be modified slightly...I had to trim a bit of the plug to get it to fit and when in place there is still two pins left free in the dash side.

Everything works fine on that side including the DCCD and little outside temperature bit(even tho I question its accuracy at times).

Only problem is I have an ABS light on constantly and the red triangle warning light......

The ABS still works perfectly.

Anybody know why this is?

Or any body have any schematics for the dash area so I can try figure it out myself??

:f reak3::fre ak3:

 

I`m a bit confused, Did you change JDM clocks for UK Hawk clocks? If so it would have been easier to just get a mph/kmh converter chip for about £25,

 

There are a few threads about this on here, pretty sure you need a second earth and/or a relay. Do a search mate and you should find what you are looking for

 

Yes my logic was that I would be able to sell my old clocks for the same amount as the ones I bought therefore converting my clocks for free...


I've tried with the searches before didn't get what I needed but I will have a try again cheers