Sigma Alarm Issue
#1
Sigma Alarm Issue
The sigma alarm on my blob keeps going off after a few hours of arming it.
It's done this since I installed some gauges.
I unplugged the gauges, and still the alarm goes off after literally 2 hours of arming it (quite consistent time-wise).
The bonnet pin is broken but not connected; and the wire is not earthing from what I can see.
It only started happening after installing the gauges so I'm wondering if I disturbed something whilst threading the senders through into the engine bay.
Anyone have diagnostics they can use with the alarm to determine the fault?
If I can find what's setting it off hopefully I can resolve it without shelling out a few hundred quid!
Either that, or anyone recommend a reasonably priced sigma specialist?
Thanks
It's done this since I installed some gauges.
I unplugged the gauges, and still the alarm goes off after literally 2 hours of arming it (quite consistent time-wise).
The bonnet pin is broken but not connected; and the wire is not earthing from what I can see.
It only started happening after installing the gauges so I'm wondering if I disturbed something whilst threading the senders through into the engine bay.
Anyone have diagnostics they can use with the alarm to determine the fault?
If I can find what's setting it off hopefully I can resolve it without shelling out a few hundred quid!
Either that, or anyone recommend a reasonably priced sigma specialist?
Thanks
#5
Sorry, quick update. Found a few online tricks tonight.
Issue appears to be the bonnet switch; am going to enable open door / bonnet / boot bleeps tomorrow and see if it beeps on arming.
Have run the diagnostic once the alarm went off and it identifies it as the bonnet switch, even though I installed a new one today; suspect it may be the cable going to the switch earthing out...
Issue appears to be the bonnet switch; am going to enable open door / bonnet / boot bleeps tomorrow and see if it beeps on arming.
Have run the diagnostic once the alarm went off and it identifies it as the bonnet switch, even though I installed a new one today; suspect it may be the cable going to the switch earthing out...
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
toyney83
General Technical
10
02 October 2015 08:38 PM