Programming Mode
#1
Scooby Regular
Thread Starter
Join Date: May 2011
Location: Abergele
Posts: 144
Likes: 0
Received 0 Likes
on
0 Posts
Programming Mode
Hi guys
I've posted on here before about my remote key fobs not working.
I've checked all locations for a keypad, to no avail.
I've tried to program from the dash [turn key 10 times etc.]
Just can't get it to even enter programming mode.
Also, just found out my power locks aren't working from inside the vehicle?
Any ideas? It's a 2005WRX.
Thanks in advance, Paul
I've posted on here before about my remote key fobs not working.
I've checked all locations for a keypad, to no avail.
I've tried to program from the dash [turn key 10 times etc.]
Just can't get it to even enter programming mode.
Also, just found out my power locks aren't working from inside the vehicle?
Any ideas? It's a 2005WRX.
Thanks in advance, Paul
Last edited by Paul-EFC; 26 September 2011 at 01:12 PM.
#4
Scooby Regular
iTrader: (3)
Join Date: Sep 2011
Location: Kent
Posts: 245
Likes: 0
Received 0 Likes
on
0 Posts
Easy test - lock the car with the window wound down and then alarm the car.
If you can reach into the car (it will test ultrasonics) and open the door then if its got an alarm it will sound.
You will find that most imports DO NOT have an alarm as its not a Jap requirement.
If you can reach into the car (it will test ultrasonics) and open the door then if its got an alarm it will sound.
You will find that most imports DO NOT have an alarm as its not a Jap requirement.
#5
Imports wouldn't have an alarm but think a cat 1 is required for sva testing and insurance so need to check urgent as if stolen might not be covered, my my05 jdm has factory fit immobiliser and aftermarket alarm upgrade
#6
As for checking for an alarm, look in the engine bay for a siren.
I presume you don't have any sensors beside the sun visors?
Thread
Thread Starter
Forum
Replies
Last Post
Mister:E
Subaru Parts
2
24 September 2015 01:37 PM