3pin to 6 pin conversion on idle control valve
29 June 2011, 05:14 PM
#1
Scooby Regular
Thread Starter
Join Date: Jun 2011
Location: NOTTINGHAM
Posts: 44
Likes: 0
Received 0 Likes
on
0 Posts
3pin to 6 pin conversion on idle control valve
Hi again all
My s reg classic wrx uk model is in need of help. My engine loom has a 3 pin connector for the idle control valve. My inlet manifold does not even have a place to mount it. Instead I have a 6 pin idle control valve mounted on the throttle body. Is there any way of using the 3 pin wiring I already have being converted into the 6 pin item actually fitted?
I thought I would ask as u guys are scooby gods
My s reg classic wrx uk model is in need of help. My engine loom has a 3 pin connector for the idle control valve. My inlet manifold does not even have a place to mount it. Instead I have a 6 pin idle control valve mounted on the throttle body. Is there any way of using the 3 pin wiring I already have being converted into the 6 pin item actually fitted?
I thought I would ask as u guys are scooby gods
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
