Alarm/Immobilser - Not working?
10 December 2010, 09:22 AM
#1
Alarm/Immobilser - Not working?
Could it be the cold?
I have a TOAD Alarm and immobilser fitted that works the C/L as well. It's now developed a fault which is winding me up. The Armed/Disarmed LED on the dash is not illuminating at all. But when you Disarm/arm using the fob the little green LED on the fob lights but **** all happens
.
However, the key will open the doors, start the car and it will run fine. I have tried both fobs but the results are the same. The original installers is coming out to have a look as it's only been in since September.
Could I have done something stupid and pressed too many buttons at the same time? Surely the car should not start at all
Anyone help?
I have a TOAD Alarm and immobilser fitted that works the C/L as well. It's now developed a fault which is winding me up. The Armed/Disarmed LED on the dash is not illuminating at all. But when you Disarm/arm using the fob the little green LED on the fob lights but **** all happens
.However, the key will open the doors, start the car and it will run fine. I have tried both fobs but the results are the same. The original installers is coming out to have a look as it's only been in since September.
Could I have done something stupid and pressed too many buttons at the same time? Surely the car should not start at all
Anyone help?
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
38
17 July 2016 10:43 PM