Cobra 6422 - programming key fob
#1
Cobra 6422 - programming key fob
Hi,
I think I am being a bit dense here. I am following the list below to try and program a key fob after replacing battery.
1. With the system disarmed switch 'ON' the ignition.
2. Insert a touch key into the touch key recepticle, the dash status L.E.D. will permanently illuminate.
3. Press both radio key buttons, together, until the radio key L.E.D. stops flashing and goes out (about ten seconds)
4. Release the buttons and the radio key L.E.D. comes 'ON'
5. Press one radio key button, the radio key L.E.D. blinks and the dashboard L.E.D. goes 'OUT' for one second.
6. Repeat steps 3 to 5 for all other legitimate radio keys. When all keys have been taught switch off the ignition. (The dashboard L.E.D. will go 'OUT').
Can someone tell me, the key fob referred to in 3 and 4 - Is this the CURRENT WORKING KEY FOB or THE NEW ONE.
I think I am being a bit dense here. I am following the list below to try and program a key fob after replacing battery.
1. With the system disarmed switch 'ON' the ignition.
2. Insert a touch key into the touch key recepticle, the dash status L.E.D. will permanently illuminate.
3. Press both radio key buttons, together, until the radio key L.E.D. stops flashing and goes out (about ten seconds)
4. Release the buttons and the radio key L.E.D. comes 'ON'
5. Press one radio key button, the radio key L.E.D. blinks and the dashboard L.E.D. goes 'OUT' for one second.
6. Repeat steps 3 to 5 for all other legitimate radio keys. When all keys have been taught switch off the ignition. (The dashboard L.E.D. will go 'OUT').
Can someone tell me, the key fob referred to in 3 and 4 - Is this the CURRENT WORKING KEY FOB or THE NEW ONE.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
toyney83
General Technical
10
02 October 2015 08:38 PM