Demister Switch Bulbs
#1
Demister Switch Bulbs
After I don't know how long I have got around to pulling the demister and hazard warning switches out. The bulbs when the lights are on have blown. Having taken the switches apart the bulbs do not look familiar. Anybody know their spec and where I might get them (web as I live in Ireland). MY99 Uk spec Turbo
Thanks Pat
Thanks Pat
#2
Scooby Regular
After I don't know how long I have got around to pulling the demister and hazard warning switches out. The bulbs when the lights are on have blown. Having taken the switches apart the bulbs do not look familiar. Anybody know their spec and where I might get them (web as I live in Ireland). MY99 Uk spec Turbo
Thanks Pat
Thanks Pat
John
#5
Scooby Regular
iTrader: (1)
Join Date: Aug 2002
Location: Bridgnorth with the Steam trains
Posts: 695
Likes: 0
Received 0 Likes
on
0 Posts
Is this the one,
I got mine from here,
The Lamp Company
part no.WT7219 12V 0.6a wire terminal
35pence each.
I got mine from here,
The Lamp Company
part no.WT7219 12V 0.6a wire terminal
35pence each.
#6
Burns spot on the order is going in this evening.
Alcazar thanks but the bulbs are tiny and smaller than those you have specified I think (bulbs are 3mm dia or less)
Once again thanks everyone
Pat
Alcazar thanks but the bulbs are tiny and smaller than those you have specified I think (bulbs are 3mm dia or less)
Once again thanks everyone
Pat
Trending Topics
#8
Scooby Regular
iTrader: (1)
Join Date: Aug 2002
Location: Bridgnorth with the Steam trains
Posts: 695
Likes: 0
Received 0 Likes
on
0 Posts
Here's a picture of the switch,you can see the tags on each side,
I just gently eased it out from underneath with a flat screwdriver and a bit of cloth on the facia.
I just gently eased it out from underneath with a flat screwdriver and a bit of cloth on the facia.
#10
Scooby Regular
iTrader: (1)
Join Date: Aug 2002
Location: Bridgnorth with the Steam trains
Posts: 695
Likes: 0
Received 0 Likes
on
0 Posts
As you can see from the picture,
the bulbs are held in a rubber housing,all you have to do is unthread the bulb wires from the housing and rethread your new bulb in the same way,and then cut off the excess.
to finish up with this ,
just trim off the excess.
the bulbs are held in a rubber housing,all you have to do is unthread the bulb wires from the housing and rethread your new bulb in the same way,and then cut off the excess.
to finish up with this ,
just trim off the excess.
Last edited by burns; 17 March 2008 at 11:18 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
jonnyboy82
Lighting and Other Electrical
0
29 September 2015 01:59 PM