Alarm interface cental locking
#1
Scooby Regular
Thread Starter
Join Date: Nov 2006
Location: Manchester
Posts: 471
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.scoobynet.com/images/icons/icon1.gif)
Im thinking of getting a Toad C4T cat 2 to 1 alarm to go with my already fitted immobiliser to make it a full cat 1 system.
only problem is im not sure if it will work the central locking on my 95 import wrx, so do i need an seperate interface to switch the central locking.
thanks
only problem is im not sure if it will work the central locking on my 95 import wrx, so do i need an seperate interface to switch the central locking.
thanks
#2
Scooby Senior
![Default](https://www.scoobynet.com/images/icons/icon1.gif)
You will need to install a 2 wire motor in the drivers door (actuator)
The toad should support reverse polarity locking, but check with the supplier first.
If you are having it installed, ask them. IIRC you will need it to be in order to have it certified as a CAT 1 alarm.
Adam
The toad should support reverse polarity locking, but check with the supplier first.
If you are having it installed, ask them. IIRC you will need it to be in order to have it certified as a CAT 1 alarm.
Adam
![Thumb](https://www.scoobynet.com/images/smilies/thumb.gif)
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
toyney83
General Technical
10
02 October 2015 08:38 PM