Setting up My DEFI's
08 December 2006, 05:17 PM
#1
Scooby Regular
Thread Starter
Join Date: Feb 2002
Location: yorkshire!!!
Posts: 523
Likes: 0
Received 0 Likes
on
0 Posts
Setting up My DEFI's
Recently had a flat battery on my STI 8 and myGauges have reset themselves and i haven,t got any instructions, anyone got any bright ideas how i can sort them out.
Cheers
Cheers
08 December 2006, 05:36 PM
#2
Not sure if they all work this way, but mine are like this:
Make sure ignition is on and then press "Warn Set", on the control unit. One of the gauges will sart to flash it's red LED.
Press either ^ or V and hold it until the needle reaches the peak you want, release the ^ or V button, and press "Warn Set" again. Another gauge will flash. Repeat as above.
Once all gauges have had their peaks set, just wait, and the "Warn Set" will cancel itself.
You can reset the peak on any gauge, any time, by pressing "Warn Set" repeatedly until the gauge you want to set, begins to flash, then as above.
Alcazar
Make sure ignition is on and then press "Warn Set", on the control unit. One of the gauges will sart to flash it's red LED.
Press either ^ or V and hold it until the needle reaches the peak you want, release the ^ or V button, and press "Warn Set" again. Another gauge will flash. Repeat as above.
Once all gauges have had their peaks set, just wait, and the "Warn Set" will cancel itself.
You can reset the peak on any gauge, any time, by pressing "Warn Set" repeatedly until the gauge you want to set, begins to flash, then as above.
Alcazar
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM