Speed Signal Wire
#1
Scooby Newbie
Thread Starter
Join Date: Dec 2005
Location: Christchurch, New Zealand
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
Speed Signal Wire
Does any one know which is the speed signal wire on the back of the instrument cluster on a JDM MY03 Sti. Need it for a TT install and figure it would be alot eaiser to wire here than going all the way to the ECU.
Thanks
Thanks
#2
Scooby Newbie
Thread Starter
Join Date: Dec 2005
Location: Christchurch, New Zealand
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
help for others
Well seen as no one on this forum seemed to know the answer to this question. Here it is. After some extensive searching and a little trial and error. The wire is located on the far right of the far right plug at the back of the cluster right behind the speedo. It is green and yellow in colour. This was on a 2003 JDM Sti. It is much eaiser to access here than at the ecu too.
#4
#5
Scooby Regular
Join Date: Apr 2005
Location: Malta
Posts: 1,084
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the diagram. I have had the connection setup on connector B135 pin 3 (black/green) for MY97 but I still not getting any output from my turbo timer. Can anyone point me where I can find the actual speed sensor, please don't redirect me to saxonfields, as it was very vague to where the position is.
#6
Scooby Regular
Join Date: Apr 2005
Location: Malta
Posts: 1,084
Likes: 0
Received 0 Likes
on
0 Posts
Problem Fixed!
I just took my cluster off and clean the circuit behind and voila, the turbo timer is making my speed. Is it just my TT or when marking the speed its a bit retarded?
I just took my cluster off and clean the circuit behind and voila, the turbo timer is making my speed. Is it just my TT or when marking the speed its a bit retarded?
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM