Dream Weaver

I'm currently trying to build a brand new wiring loom for my 205 for its new programmable ECU, and I need some stranded 0.5-1.0mm2 wire.

Anyone know a decent place to buy some, tried Maplins website but couldnt fine anything.

The wire will run the entire ECU and sensor setup, including coils, injectos, TPS etc.

Vegescoob

Vehicle Wiring Products Ilkeston Derbyshire. Haven't got website or tel no. with me but they advertise in car mags and have just about everything for vehicle electrics.

NeilA

Just seen above - was about to post - I tend to use www.vehicle-wiring-products.co.uk - reasonable prices (I think) and fairly helpful if you ring them.

Vegescoob

Bit obvious I tried www.vehiclewiringproducts.co.uk It worked.

Dream Weaver

Thanks all, anyone know which wire on their site would be suitable?

Instructions just say use stranded 0.5-1.0mm2.

alcazar

iTrader: (2)

Give e'm a ring, they are the experts, and you can order over the phone too.


Alcazar

Vegescoob

Like all cables carrying electrical current the size to use is dependant on how the cables are being used. For instance if you are making a large loom with the cables tightly wrapped together and then run through sleeving or conduit and then in a hot engine bay you would use a larger size than for a few wires in the interior. I'm sure Vehicle Wiring Products have some info ref this or could point you in the right direction ref any books that could help.