How to adjust Prodrive spotlights?
#2
There's three 10mm bolts holding them in. They're under the plastic cover.
Put a small screwdriver into the slot on the inboard side of the cover and carefully pull the cover away from the car, put your fingers in the gap and move them round the cover, tugging each clip in turn away fro the car.
The three bolts are one at the top (on the outside edge) which is fixed then two at the bottom which are spring mounted. To lower the light tighten the bottom two equally a couple of turns and recheck it. To move it side to side just adjust one at a time.
When it's right put the cover back on, it just pops back into place.
Put a small screwdriver into the slot on the inboard side of the cover and carefully pull the cover away from the car, put your fingers in the gap and move them round the cover, tugging each clip in turn away fro the car.
The three bolts are one at the top (on the outside edge) which is fixed then two at the bottom which are spring mounted. To lower the light tighten the bottom two equally a couple of turns and recheck it. To move it side to side just adjust one at a time.
When it's right put the cover back on, it just pops back into place.
#4
Scooby Senior
Thread Starter
Hmm.. I tried this on Sunday, but could only clear the 2 lugs on the inside edge of the spotlight assembly. Can anyone tell me where the other lugs are please? I'm doing this with a screwdriver wrapped in a towell - so I don't scratch anything. Is there a better tool?
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM