morrettes wiring diagram MY01
morrettes wiring diagram MY01
right,can anyone help?
25 May 2004, 10:10 PM
#2
Scooby Regular
Cant help with a diagram, but if no one else can get you one ,your welcome to have a look at my MY01 morrette lights if your localish.
Phil (feeling in a good mood)
Phil (feeling in a good mood)
26 May 2004, 01:00 AM
#3
Scooby Regular
Join Date: Aug 2000
Posts: 2,830
Likes: 0
Received 0 Likes
on
0 Posts
Prepare for a very gash drawing 
- I can give you a rough overview of the wiring as I've got HIDs
The bulbs are connected to a ballast unit by a thickish (high voltage) cable. The other connector to the ballast is the power supply. This is connected to the battery with a power relay (30A capacity) as a switch. The relay is triggered by wires from your existing light connectors, i.e. when you turn on the lights, the relay contacts and lets power get to the HID ballasts directly from the battery so you don't overload the car loom wiring.
This might be a start but watch out for the ballasts being live - they spark up the lamps at something like 23kV
and then settle down to sensible figures so be careful / safe etc
Andy
- I can give you a rough overview of the wiring as I've got HIDs The bulbs are connected to a ballast unit by a thickish (high voltage) cable. The other connector to the ballast is the power supply. This is connected to the battery with a power relay (30A capacity) as a switch. The relay is triggered by wires from your existing light connectors, i.e. when you turn on the lights, the relay contacts and lets power get to the HID ballasts directly from the battery so you don't overload the car loom wiring.
This might be a start but watch out for the ballasts being live - they spark up the lamps at something like 23kV
and then settle down to sensible figures so be careful / safe etcAndy
Thread
Thread Starter
Forum
Replies
Last Post
Flat4x4-again
General Technical
2
29 September 2015 06:32 PM