Front fog-light pin-outs
#1
Scooby Regular
Thread Starter
Join Date: Jun 2000
Posts: 13,735
Likes: 0
Received 0 Likes
on
0 Posts
OK, so an hour with a multimeter would do this, but does anyone have the pin-outs or wiring diagram for the front fog-light switch?
I want to use it as an override switch for my PIAAs, which I've wired to switch on high beam.
I want to retain illumination, and the illumination tell-tale too. There's five wires on there. Dash illumination+ground, +12 in, switched out and ground for telltale lamp are my guesses.
Anyone know the wiring diagram? I want to replace the +12 in and switched out...
(The car is MY00)
I want to use it as an override switch for my PIAAs, which I've wired to switch on high beam.
I want to retain illumination, and the illumination tell-tale too. There's five wires on there. Dash illumination+ground, +12 in, switched out and ground for telltale lamp are my guesses.
Anyone know the wiring diagram? I want to replace the +12 in and switched out...
(The car is MY00)
#2
Scooby Regular
iTrader: (7)
Join Date: Jun 2001
Location: Stalking Kate Beckinsale
Posts: 4,265
Likes: 0
Received 0 Likes
on
0 Posts
Not going to add anything constructive to this, but just to comment on the fact that I have gone through your web site and have just one thing to say. My, you really are quite the 'Tweak Monkey', aren't you?
#3
i've got the wiring diagram at work somewhere i will dig it out and tell you what to do , but as far as i can remember there are only 2 wires which you need to cut and tape up and then connect the wires from the lights to the ends that are left on the switch.
this is quite a common question that we get asked when fitting the piaa's so we looked in to it
this is quite a common question that we get asked when fitting the piaa's so we looked in to it
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM