?? MAPDCCD No power at handbrake switch or brake fluid switch?
#1
Scooby Regular
Thread Starter
?? MAPDCCD No power at handbrake switch or brake fluid switch?
Hi fellas
im just trying to get all wiring ready before I fit a mapdccd controller
it requires a wire from the handbrake switch. So then I noticed I’ve no light coming onto the dash for handbrake on
tested it, no power there, no blown fuses
any ideas what I can do?
Spent hours online trying to find Subaru workshop wiring diagrams. Thats hard enough. I think the manuals are US models
Is is just a case of checking for power with a multimeter?
thanks
im just trying to get all wiring ready before I fit a mapdccd controller
it requires a wire from the handbrake switch. So then I noticed I’ve no light coming onto the dash for handbrake on
tested it, no power there, no blown fuses
any ideas what I can do?
Spent hours online trying to find Subaru workshop wiring diagrams. Thats hard enough. I think the manuals are US models
Is is just a case of checking for power with a multimeter?
thanks
#2
Scooby Regular
From the MY01 UK/European Impreza workshop manual (assuming you are refering to a 2001 Bugeye WRX ???)
You can download all the sections for the MY01 (2001) European/Australia/General model Imprezas here (65 PDF's)
http://ken-gilbert.com/01-impreza-service-manuals
You can download all the sections for the MY01 (2001) European/Australia/General model Imprezas here (65 PDF's)
http://ken-gilbert.com/01-impreza-service-manuals
Last edited by Don Clark; 03 May 2020 at 08:27 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Nick Read
Lighting and Other Electrical
4
14 August 2005 10:16 AM